Description

EUROSTONE BOND is the first polymeric sand, specifically designed for natural stone pavers. It can be used in a traditional and overlay base systems application. It is perfect for pool sides, patios, foot paths, driveways, stone apron driveways, parking spaces, stone roads and piazzas. This complete multipurpose polymeric sand is available in Slate Grey. It sets above the freezing temperature 32°F (0°C) and can be used for joints up to a maximum of 1.5” (3.8 cm).

IDEAL FOR:

• Residential and commercial use
• Traditional and Overlay applications
• Natural stone and Cobble pavers
• Pool sides, patios, foot paths, driveways, stone apron driveways, parking spaces, stone roads and piazzas

FEATURES & BENEFITS:

• Can be used for stone joints up to a maximum of 1.5″ (3.8 cm)
• Traditional applications, rain safe 1 hour after water activation
• Overlay applications, rain safe 24 hours after water activation
• Works above 32°F (0°C)
• Does not haze natural stone pavers
• Will resist mechanical brooming
• In vehicular application stone must be interlocked or adhered to a concrete bed
• Waterproof bags: Lay the bag flat on its back, so the front of the bag is facing you. Intact pallets can be stored outdoors
• 15-Year Limited Warranty

IMPORTANT INSTALLATION NOTES:

1. Always refer to the latest EUROSTONE BOND Technical Data Sheet (TDS) at AllianceGator.com before installing EUROSTONE BOND.
2. Do not apply if the natural stone paver surfaces and joints are damp or wet. The damp or wet surfaces and joints will cause EUROSTONE BOND to prematurely activate and will lead to the polymers sticking on the stones paver surfaces and properly sliding into the joints and obtaining very densely packed joints, which is critical to the products performance. Do not use if rain is expected within 24 hours. Avoid excessive watering or flooding of natural stone paver surfaces.
3. For all natural stone paver surfaces, and particularly around in ground pools there must be a slope of 1/8″ (3 mm) per linear foot away from the edge of the pool, or structures, to ensure optimal performance of the EUROSTONE BOND. For the pool coping units it is mandatory to use mortar in the joints. For the rest of the natural stone paver installation around the pool, you can use EUROSTONE BOND.
4. Do not sweep EUROSTONE BOND over asphalt.
5. The EUROSTONE BOND level must be at least 1/8″ (3 mm) below top of the natural stone paver’s surface or 1/8″ (3 mm) below the chamfer or erosion may occur.
6. The filled and cured polymeric sand joints should never be in direct contact with foot traffic or tires. The product must only be used as a recessed jointing material.

PLEASE NOTE: